Previous Topic
Mapping Table Dialog Box
You can use the Mapping Table dialog box to define the mapping relationship, based on which to set up the filter relationship between the primary report and the linked report. This topic describes the options in the dialog box.
Designer displays the Mapping Table dialog box when you select Mapping Table in the Insert Link dialog box or Edit Link dialog box.
You see the following options in the dialog box:
Fields (Primary)
This column shows the fields in the primary report that you select to set up the mapping relationship.
This drop-down list in the column contains all the fields in the data resource used by the data component that contains the trigger object in the primary report. Select a field that is bound with an on-screen filter to define the mapping relationship.
Fields (Linked)
This column shows the fields in the linked report that you select to set up the mapping relationship.
This drop-down list in the column contains all the fields in the data resource used by the selected component in the linked report, which are of the same data type as the specified primary report field. Select a field whose values are the same as those of the specified primary report field, then when the link is triggered at runtime, Logi Report Engine applies the corresponding on-screen filter in the primary report to the selected linked report field.
Add button
Select to add a mapping line.
Remove button
Select to delete the specified mapping line.
OK
Select to apply your settings and close the dialog box.
Cancel
Select to close the dialog box without saving any changes.
Help
Select to view information about the dialog box.
Back to top